NFPA 72 states: Life safety from fire in residential occupancies is based primarily on early notification to occupants of the need to escape, followed by the appropriate egress actions by those occupants. ! WARNING: PLEASE READ CAREFULLY AND THOROUGHLY The smoke alarm takes precedence when both smoke and carbon monoxide are present. When smoke particles in the smoke sensor reach a specified concentration, the alarm/voice message warning system will sound, and be accompanied by the flashing red LED light. The smoke alarm monitors the air for products of combustion that are produced when something is burning or smoldering. Battery reminder flag that prohibits installation when batteries are not present.Tamper Resist Feature that deters children and others from removing the alarm (see page 17).Green and red LED lights that indicate normal operation and alarm status (see page 16 and 17 for details).Alarm Memory Feature that gives visual indication when an alarm has sensed a hazardous condition.Peak Level Memory Feature which alerts user when the unit has detected CO concentrations of 100 ppm or greater (see page 16).HUSH Control Feature that silences the unit during nuisance alarm situations (see page 15).Test/Reset button performs functions.(See page 14).If this occurs call the Product Support Line at 1-80. One “chirp” every 30 seconds coupled with a green LED flash twice a second is an indication that the alarm is malfunctioning.At end of product life, the button can be pushed to silence the end of life "chirp" for approximately 3 days at a time, for a maximum of 30 days life extension. – System announces “PUSH TEST BUTTON” when the unit is powered up, reminding user to activate the Test Button. System announces “CAUTION, CARBON CONOXIDE PREVIOUSLY DETECTED” when the unit has detected CO concentrations of 100 ppm or higher. System announces “HUSH MODE CANCELLED” when unit resumes normal operation after Hush Mode has been cancelled. System announces “HUSH MODE ACTIVATED” when the unit is first put into HUSH Mode. Voice Message System that alerts user to the following conditions:.Under battery power, the "LOW BATTERY" voice only occurs once every 15 minutes. LOW BATTERY: When the batteries are low and need replacing the red LED light will flash and the unit will “chirp” one time, followed by the warning message “LOW BATTERY.” This cycle will occur once every minute and will continue for at least seven days. The red Light Emitting Diode (LED) light will flash while in alarm/voice mode. While powered by battery only, after four minutes the alarm/voice pattern will sound once every minute. This continues until the unit is reset or the CO is eliminated. The red LED light will flash while in alarm/voice mode.ĬARBON MONOXIDE: The alarm/voice pattern is four short alarm beeps followed by the verbal warning message “WARNING! CARBON MONOXIDE!". Alarm/Voice message warning system that alerts you of the following conditions in the manner described below, thus eliminating any confusion over which alarm is sounding:įIRE: The alarm/voice pattern is three long alarm beeps followed by the verbal warning message “FIRE!” This pattern is repeated until the smoke is eliminated.Interconnectable to other Kidde/Nighthawk brand smoke and CO alarms (see page 15 for details).Powered by 120V AC (60 Hz, 45mA max) wire-in connector and two AA battery backup.Smoke alarm takes precedence when both smoke and carbon monoxide are present.Permanent independent smoke and carbon monoxide sensors.Limited Warranty and Service Information. Pages 23-24Įnd of Product Life Notification. Pages 20Īlarm Removal/Battery Replacement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |